TOPIC : Highly flexible and efficient fossil fuel power plants
|Publication date:||14 October 2015|
|Types of action:||RIA Research and Innovation action|
|DeadlineModel: Opening date:||single-stage 20 September 2016||Deadline:||05 January 2017 17:00:00|
|Time Zone : (Brussels time)|
03 January 2017 14:30
As of 1 January 2017, Switzerland is fully associated to H2020.
Please read this note for further details:
Topic DescriptionSpecific Challenge:
The share of energy produced from renewable resources is growing rapidly. The output of wind and solar power is highly variable, and depends of factors such as weather conditions and time of day. With this growing share of renewable power, in particular when having priority access to the grid, fossil fuel power plants will have to increasingly shift their role from providing base-load power to providing fluctuating back-up power to meet unpredictable and short-noticed demand peaks, in order to control and stabilise the grid. Plants should be able to run both at the lowest part load possible at the highest possible efficiency. Moreover, plants will be required to operate across the entire load range with high load-change velocities, and even operate in start/stop mode with full turndown and very fast re-start, all at minimal (lifetime) fuel consumption. This forces base-load plants to operate through significantly more thermal cycles, leading to increased rate of wear on plant components. Operational flexibility therefore presents a significant challenge for fossil fuel power (and CHP) plants.Scope:
Focus on progressing solutions that already reached TRL 3 to TRL 4-6 (please see part G of the General Annexes) and offer the highest potential for a deeper integration into an advanced energy system with ever higher shares of renewable energies, for both existing (retrofitting) and new thermal power plants. Solutions with lowest greenhouse gas emissions, residue disposal and water need per energy unit are preferred. Collaboration with power plant operators is strongly encouraged. Support will not be given to projects that provide performance improvements that are not related to load fluctuations.
The Commission considers that proposals requesting a contribution from the EU in the range of EUR 3 to 6 million would allow this specific challenge to be addressed appropriately. Nonetheless, this does not preclude submission and selection of proposals requesting other amounts.Expected Impact:
Projects should lead to innovative and cost-effective solutions to improve the ability of new and/or existing dispatchable thermal power plants to meet fast load changes, in order to better support the grid due to fluctuations in energy peak demand and power output from renewable sources, at minimal fuel consumption and emissions, while mitigating the effects of cycling operation to avoid excessive wear and service life expenditure, and not impeding the potential CO2 capture readiness of the power plants.Cross-cutting Priorities:
Topic conditions and documents
Please read carefully all provisions below before the preparation of your application.
IMPORTANT: Please also read the introductory policy context for the activity TOWARDS AN INTEGRATED EU ENERGY SYSTEM of the COMPETITIVE LOW CARBON ENERGY call under the Societal Challenge 3 'Secure, Clean and Efficient Energy' of the Work Programme 2016 - 2017.
- List of countries and applicable rules for funding: described in part A of the General Annexes of the General Work Programme.
Note also that a number of non-EU/non-Associated Countries that are not automatically eligible for funding have made specific provisions for making funding available for their participants in Horizon 2020 projects. See the information in the Online Manual.
- Eligibility and admissibility conditions: described in part B and C of the General Annexes of the General Work Programme.
Proposal page limits and layout: Please refer to Part B of the standard proposal template.
3.1 Evaluation criteria and procedure, scoring and threshold: described in part H of the General Annexes of the General Work Programme.
3.2 Submission and evaluation process: Guide to the submission and evaluation process.
- Indicative timetable for evaluation and grant agreement:
Information on the outcome of single-stage evaluation: maximum 5 months from the deadline for submission.
Signature of grant agreements: maximum 8 months from the deadline for submission.
- Provisions, proposal templates and evaluation forms for the type(s) of action(s) under this topic:
Research and Innovation Action:
Specific provisions and funding rates
Proposal templates are available after entering the submission tool below.
Standard evaluation form
H2020 General MGA -Multi-Beneficiary
Annotated Grant Agreement
- Additional provisions:
Horizon 2020 budget flexibility
Technology readiness levels (TRL) – where a topic description refers to TRL, these definitions apply.
Financial support to Third Parties – where a topic description foresees financial support to Third Parties, these provisions apply.
- Open access must be granted to all scientific publications resulting from Horizon 2020 actions.
Where relevant, proposals should also provide information on how the participants will manage the research data generated and/or collected during the project, such as details on what types of data the project will generate, whether and how this data will be exploited or made accessible for verification and re-use, and how it will be curated and preserved.
Open access to research data
The Open Research Data Pilot has been extended to cover all Horizon 2020 topics for which the submission is opened on 26 July 2016 or later. Projects funded under this topic will therefore by default provide open access to the research data they generate, except if they decide to opt-out under the conditions described in annex L of the Work Programme. Projects can opt-out at any stage, that is both before and after the grant signature.
Note that the evaluation phase proposals will not be evaluated more favourably because they plan to open or share their data, and will not be penalised for opting out.
Open research data sharing applies to the data needed to validate the results presented in scientific publications. Additionally, projects can choose to make other data available open access and need to describe their approach in a Data Management Plan.
- Projects need to create a Data Management Plan (DMP), except if they opt-out of making their research data open access. A first version of the DMP must be provided as an early deliverable within six months of the project and should be updated during the project as appropriate. The Commission already provides guidance documents, including a template for DMPs.
- Eligibility of costs: costs related to data management and data sharing are eligible for reimbursement during the project duration.
The legal requirements for projects participating in this pilot are in the article 29.3 of the Model Grant Agreement.
- Additional documents
- H2020 Work Programme 2016-17: Introduction
- H2020 Work Programme 2016-17: Secure, clean and efficient energy
- H2020 Work Programme 2016-17: Dissemination, Exploitation and Evaluation
- H2020 Work Programme 2016-17: General Annexes
- Legal basis: Horizon 2020 - Regulation of Establishment
- Legal basis: Horizon 2020 Rules for Participation
- Legal basis: Horizon 2020 Specific Programme
Please note that the topic LCE-01-2016-2017 will open again on 20/09/2016 with the deadline of 14/02/2017, subject to the final decision on 2017 budget appropriations.
No submission system is open for this topic.
H2020 Online Manual your online guide on the procedures from proposal submission to managing your grant.
Participant Portal FAQ – Submission of proposals.
National Contact Points (NCP) - contact your NCP for further assistance.
Research Enquiry Service – ask questions about any aspect of European research in general and the EU Research Framework Programmes in particular.
Enterprise Europe Network – contact your EEN national contact for advice to businesses with special focus on SMEs. The support includes guidance on the EU research funding.
IT Helpdesk- contact the Participant Portal IT helpdesk for questions such as forgotten passwords, access rights and roles, technical aspects of submission of proposals, etc.
Ethics – for compliance with ethical issues, see the Participant Portal and Science and Society Portal
European IPR Helpdesk assists you on intellectual property issues
CEN and CENELEC, the European Standards Organisations, advise you how to tackle standardisation in your project proposal. Contact CEN-CENELEC Research Helpdesk at firstname.lastname@example.org.
The European Charter for Researchers and the Code of Conduct for their recruitment
Partner Search Services help you find a partner organisation for your proposal