This site has been archived on 02/02/2015

Navigation path

This website is no longer being updated.

Please visit the new Internal Market, Industry, Entrepreneurship and SMEs website.

Mechanical engineering

Directive 95/16/EC on lifts

The European Parliament and Council Directive 95/16/EC of 29 June 1995 on the approximation of the laws of the Member States relating to lifts establishes European legal requirements for the design, installation and placing on the market of new lifts. It also sets out the conformity assessment procedures to be followed by lift installers to ensure conformity with these requirements. The provisions of the Directive are implemented in the national law of each Member State of the European Union.

The Directive covers new lifts permanently installed in buildings and constructions for carrying passengers or passengers and loads. It also applies to certain safety components for lifts listed in Annex IV of the Directive.

Directive 95/16/EC

Amendment to the Directive pdf - 78 KB [78 KB] (Regulation (EC) No 1882/2003 of the European Parliament and of the Council of 29 September 2003 adapting to Council Decision 1999/468/EC the provisions relating to committees which assist the Commission in the exercise of its implementing powers laid down in instruments subject to the procedure referred to in Article 251 of the EC Treaty - OJ L 284, 31/10/2003)

Directive 95/16/EC (consolidated text)

Declaration by the European Parliament, the Council and the Commission


Share: FacebookGoogle+LinkedInsend this page to a friend

Set page to normal font sizeIncrease font size by 200 percentprint this page